Cisco ASR 9000 Series Configuration Manual page 256

Static join
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 router mld
Example:
RP/0/RSP0/CPU0:router(config)# router mld
Step 3
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-mld)# interface
pw-ether1
Step 4
static-group ip-group-address source-address
Example:
RP/0/RSP0/CPU0:router(config-mld-default-if)#
static-group ff35::e100 2000:10::1
Step 5 exit
Example:
RP/0/RSP0/CPU0:router(config-mcast-ipv4)# exit
Step 6 commit
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
242
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters the MLD multicast routing configuration
mode.
Enters the pseudowire interface configuration mode.
Enables pw-ether1 interface to statistically join a
multicast group.
Exits the current configuration mode.
This step can be used, more than
Note
once.