Cisco ASR 9000 Series Configuration Manual page 226

Configuring Multicast VPN
Command or Action
Step 4
mdt source loopback 0
Example:
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)# mdt
source loopback 0
Step 5
exit
Example:
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)# exit
Step 6
vrf 101
Example:
RP/0/RSP0/CPU0:router(config-mcast)# vrf 101
Step 7
address-family ipv4
Example:
RP/0/RSP0/CPU0:router(config-mcast-101)# address-family
ipv4
Step 8
mdt source loopback 1
Example:
RP/0/RSP0/CPU0:router(config-mcast-101-ipv4)# mdt source
loopback 1
Step 9 Repeat the steps 6 to 8, as many times as needed to create other
VRFs.
Example:
RP/0/RSP0/CPU0:router(config-mcast)# vrf 102 mdt source
loopback 2
Step 10
commit
Step 11
show pim vrf all mdt interface
Example:
RP/0/RSP0/CPU0:router# show pim vrf all mdt interface
GroupAddress
239.0.0.239
VRF_NAME
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
212
Interface
mdtVRF_NAME
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Configures the interface used to set the MDT
source address for MVPN, using the default
VRF.
Exits from the current mode.
Enters the IPv4 address-family mode.
Configures the interface used to set the MDT
source address for MVPN.
—
To verify the MDT source per VRF
configuration, use the show pim vrf all mdt
interface command.
Source Vrf
Loopback1