Cisco ASR 9000 Series Configuration Manual page 278

Configuring IPv4 Multicast VPN: Example
CE4:
For information about configuring the CE router, using Cisco IOS software, see the appropriate Cisco IOS
software configuration documentation.
interface Loopback0
ipv4 address 101.101.101.101 255.255.255.255
!
interface GigabitEthernet0/0/0/0
ipv4 address 101.1.1.2 255.255.255.0
!
interface GigabitEthernet0/0/0/3
ipv4 address 11.1.1.1 255.255.255.0
!
multicast-routing
address-family ipv4
interface all enable
!
!
!
route-policy pass-all
pass
end-policy
!
router bgp 400
bgp router-id 101.101.101.101
address-family ipv4 unicast
redistribute connected
!
neighbor 101.1.1.1
remote-as 100
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
!
!
!
router pim vrf default address-family ipv4
rp-address 2.2.2.2
interface Loopback0
!
interface GigabitEthernet0/0/0/0
!
interface GigabitEthernet0/0/0/3
!
!
end
CE3:
For information about configuring the CE router, using Cisco IOS software, see the appropriate Cisco IOS
software configuration documentation.
interface Loopback0
ipv4 address 122.122.122.122 255.255.255.255
!
interface GigabitEthernet0/1/3/0
ipv4 address 22.1.1.1 255.255.255.0
!
interface GigabitEthernet0/2/3/0
ipv4 address 122.1.1.2 255.255.255.0
multicast-routing
address-family ipv4
interface all enable
!
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
264
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software