Enabling Multicast On Pw-He Interfaces - Cisco ASR 9000 Series Configuration Manual

Enabling multicast on PW-HE interfaces

Enabling multicast on PW-HE interfaces
This task enables multicast on PW-HE interfaces.
SUMMARY STEPS
1. configure
2. multicast-routing [address-family {ipv4 | ipv6}]
3. interface pw-ether1
4. enable
5. exit
6. vrf vrf-name
7. address-family ipv4
8. interface type interface path-id
9. enable
10. exit
11. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 multicast-routing [address-family {ipv4 | ipv6}]
Example:
RP/0/RSP0/CPU0:router(config)# multicast-routing
address-family ipv4
Step 3
interface pw-ether1
Example:
RP/0/RSP0/CPU0:router(config-mcast-ipv4)# interface
pw-ether1
Step 4 enable
Example:
RP/0/RSP0/CPU0:router(config-mcast-ipv4)# enable
Step 5 exit
Example:
RP/0/RSP0/CPU0:router(config-mcast-ipv4)# exit
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
240
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters multicast routing configuration mode.
Enters the pseudowire interface configuration
mode.
Enables multicast routing on pseudowire interfaces.
Exits the current configuration mode.