Associating A Route Policy To Pim Configuration For The Vrf Receiving Igmp Reports; Configuration Examples For Implementing Multicast Routing On Software; Dns-Based Ssm Mapping: Example - Cisco ASR 9000 Series Configuration Manual

Associating a route policy to PIM configuration for the VRF receiving IGMP reports

Associating a route policy to PIM configuration for the VRF receiving IGMP
reports
SUMMARY STEPS
1. configure
2. router pim vrf vrf-name address-family ipv4
3. rpf-topology route-policy policy-name
4. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 router pim vrf vrf-name address-family ipv4
Step 3 rpf-topology route-policy policy-name
Example:
RP/0/RSP0/CPU0:router(config-rpl)# rpf-topology
extranet-igmp-reports
Step 4
commit
Configuration Examples for Implementing Multicast Routing on
Software
This section provides the following configuration examples:

DNS-based SSM Mapping: Example

The following example illustrates DNS-based SSM Mapping configuration.
multicast-routing
address-family ipv4
nsf
mdt source Loopback5
maximum disable
interface all enable
accounting per-prefix
!
address-family ipv6
nsf
maximum disable
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
252
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters PIM address-family IPv4 submode.
Associates a previously defined route-policy with
the non-default VRF that receives the IGMP reports.