Flow-Based Mofrr - Cisco ASR 9000 Series Configuration Manual

Configuring MoFRR

Flow-based MoFRR

SUMMARY STEPS
1. configure
2. ipv4 access-list acl-name
3. sequence number [permit|deny] ipv4 host address [host address | any]
4. exit
5. router pim
6. mofrr acl-name
7. commit
8. show mfib hardware route summary location
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 ipv4 access-list acl-name
Example:
RP/0/RSP0/CPU0:router (config)# ipv4 access-list
flow_mofrr
Step 3 sequence number [permit|deny] ipv4 host address [host
address | any]
Example:
RP/0/RSP0/CPU0:router(config-ipv4-acl) #10 permit
ipv4 host 20.0.0.2 any
Step 4 exit
Example:
RP/0/RSP0/CPU0:router(config-ipv4-acl)# exit
Step 5
router pim
Example:
RP/0/RSP0/CPU0:router(config)# router pim
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
236
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters IPv4 access list configuration mode and
configures the named access list.
Specifies one or more conditions allowed or denied in
the created IPv4 access list.
Saves the MoFRR acl configuration and exists the IPv4
acl configuration mode. You need to exit twice here.
Enters the PIM configuration mode.