Configuring Tail Pe Router (For Mofrr) - Cisco ASR 9000 Series Configuration Manual

Configuring MoFRR
Command or Action
Step 3
mofrr
Example:
RP/0/RSP0/CPU0:router(config-pim)# mofrr
Step 4
mofrr acl-name
Example:
RP/0/RSP0/CPU0:router(config-pim-ipv4-mofrr)#
flow acl1
Step 5
clone source S to S1 S2masklenn
Example:
RP/0/RSP0/CPU0:router(config-pim-ipv4-mofrr)#
clone source 10.1.1.1 to 20.2.2.2 50.5.5.5
masklen 32
Step 6 commit
Step 7 show pim topology route
Example:
RP/0/RSP0/CPU0:router# show pim topology
232.0.0.1

Configuring Tail PE Router (for MoFRR)

•
SUMMARY STEPS
1. configure
2. router pim [address-family ipv4]
3. mofrr
4. mofrr acl-name
5. clone join S to S1 S2masklenlength
6. rpf-vector sourcemasklenlength
7. commit
8. show mfib hardware router mofrr routelocationinterface-path-id
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
238
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters PIM Multicast only FRR configuration mode.
Enables MoFRR with hardware switchover triggers for the
specified access-list.
Duplicates source (S) to S1 and S2 with the specified mask
length. A mapping is created between (S,G) , (S1,G) and
(S2,G). S1 is the primary path and S2 is the secondary path.
This command verifies the mapping between the source S
and S1 and S2. S, S1, S2 entries are updated in the displayed
MoFRR details.