Vrf-Policy - Cisco NCS 540 Series Routers Command Reference Manual

vrf-policy

vrf-policy

To apply a policy on a per VPN routing and forwarding (VRF) basis, use the vrf-policy command in global
configuration mode. To remove the association of the policy on a VRF, use the no form of this command.
vrf-policy vrf vrf-name address-family {ipv4 | ipv6 } policy type pbr input policy-name
no vrf-policy vrf vrf-name address-family {ipv4 | ipv6 } policy type pbr input policy-name
Syntax Description
vrf vrf-name
policy type pbr input policy-name
No default action.
Command Default
Policy map class configuration
Command Modes
Command History
Release
Release 6.0.1
This command is supported with sub-mode. This command applies only to the incoming IPv4 packets only.
Usage Guidelines
Use this command to apply a PBR policy on a per VRF basis during the classification and decapsulation of
GRE packets.
Task ID
Task
ID
qos
Examples
This example shows how to apply an already configured policy on a per VRF basis:
/* Configuring a VRF */
RP/0/RP0/CPU0:router(config)# vrf gre-vrf address-family ipv4 unicast
...
/* Configuring a policy */
RP/0/RP0/CPU0:router(config)# policy-map type pbr gre-policy
...
/* Applying the policy on the VRF */
RP/0/RP0/CPU0:router(config)# vrf-policy vrf gre-vrf address-family ipv4 policy type pbr
input gre-policy
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
48
Operations
read,
write
Sets the VRF name.
Sets the policy name.
Congestion Management Commands
Modification
This command was introduced.