Configuration Examples For Configuring The Tail-End Router; Configuration Examples For Configuring Guaranteed Bandwidth Service - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 20
Configuring Quality of Service for MPLS Traffic
Configuration Examples for Configuring the Tail-End Router
This section provides the following examples of how to configure DS-TE on the tail-end router:
•
•
Note
Do not configure tunnel interfaces on the tail-end router.
Configuration Example for Configuring DS-TE on the Tail-End Router
Example 20-9
protocol and the loopback0 virtual interface.
Example 20-9 Configuring DS-TE on the Tail-End Router
router-3(config)# mpls traffic-eng tunnels
router-3(config)# router isis
router-3(config-router)# net 49.0000.1000.0000.0013.00
router-3(config-router)# metric-style wide
router-3(config-router)# is-type level-1
router-3(config-router)# mpls traffic-eng level-1
router-3(config-router)# passive-interface loopback0
router-3(config-router)# mpls traffic-eng router-id loopback0
router-3(config-router)# exit
router-3(config)# interface loopback0
router-3(config-if)# ip address 10.24.1.1 255.255.255.255
router-3(config-if)# no ip directed-broadcast
router-3(config-if)# ip router isis
router-3(config-if)# exit
Configuration Example for Configuring DS-TE on the Tail-End Physical Interfaces
Example 20-10
configuration uses the IS-IS routing protocol.
Example 20-10 Configuring DS-TE on the Tail-End Physical Interface
router-1(config)# interface POS4/0
router-1(config-if)# ip address 10.12.1.3 255.255.255.0
router-1(config-if)# mpls traffic-eng tunnels
router-1(config-if)# ip rsvp bandwidth 130000 130000 sub-pool 80000
router-1(config-if)# ip router isis
router-1(config-if)# exit
Configuration Examples for Configuring Guaranteed Bandwidth Service
For examples of guaranteed bandwidth configuration, see the MPLS Traffic Engineering—DiffServ
Aware, Release 12.2(14)S feature module.
OL-7433-09
Configuration Example for Configuring DS-TE on the Tail-End Router, page 20-31
Configuration Example for Configuring DS-TE on the Tail-End Physical Interfaces, page 20-31
activates DS-TE globally on the tail-end router. This example configures the IS-IS routing
activates DS-TE on the physical interface POS 4/0 of the tail-end router. This example
Cisco 10000 Series Router Quality of Service Configuration Guide
MPLS Traffic Engineering—DiffServ Aware
20-31
Advertisement
Chapters
Table of Contents
