Configuring Vpls Lsm: Examples; Enabling P2Mp Pw With Rsvp-Te On A Vfi - Cisco ASR 9000 Series Configuration Manuallines

Implementing Multipoint Layer 2 Services
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-class gre
Configures the pseudowire class name.
Step 4
encapsulation mpls
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)# encapsulation mpls
Configures the pseudowire encapsulation to MPLS.
Step 5 preferred-path { interface } { tunnel-ip value | tunnel-te value | tunnel-tp value } [ fallback disable ]
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-encap-
mpls)# preferred-path interface tunnel-ip 1 fallback disable
Configures preferred path tunnel settings. If the fallback disable configuration is used and once the TE/TP tunnel is
configured as the preferred path goes down, the corresponding pseudowire can also go down.
Note Ensure that fallback is supported.
Step 6
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring VPLS LSM: Examples

This section provides examples on how to configure the VPLS LSM solution:

Enabling P2MP PW with RSVP-TE on a VFI

Perform this task to enable a P2MP pseudowire with RSVP-TE on a VFI.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. vfi { vfi-name }
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring VPLS LSM: Examples
313