Rf Connector - Promax HD RANGER+ Manual

8.4

RF Connector

DiSEqC commands:
►
The RF connector allows controlling an antenna using DiSEqC commands. DiSEqC
(Digital Satellite Equipment Control) is a communication protocol between the
satellite receiver and the installation accessories of satellite (switches, LNBs,
etc.) proposed by Eutelsat, in order to standardize the diversity of switching
protocols (13 to 18 V, 22 kHz) and meet the needs of the installations for the
reception of digital TV.
Connect the RF cable
signal of the equipment.
Press the Spectrum key
Press the Settings key
Select the polarization (horizontal/vertical) and the satellite band
(high/low).
If necessary, enable the Supply output and select the supply voltage
for the LNB.
On the Settings menu, select the option DiSEqC mode.
Two new functions appear on the softkeys: Command
Software
Select the command or program and press the joystick to send it to
the antenna. These commands or programs allow the user to control
an antenna (for more information about DiSEqC commands and
programs see
April 2013
(see Figure
to access the spectrum analyser mode.
and select the satellite band.
.
Annex 3).
6) to the RF connector for the input
and
8-89