Example For Configuring Remote Port Mirroring - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
#
traffic behavior b1
mirroring to observe-port 1
#
traffic policy p1
classifier c1 behavior b1
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
traffic-policy p1 inbound
trust 8021p
#
interface Ethernet0/0/3
port link-type trunk
port trunk allow-pass vlan 10
#
interface Ethernet0/0/5
port link-type trunk
port trunk allow-pass vlan 10
traffic-policy p1 inbound
trust 8021p
#
interface Ethernet0/0/24
#
return

8.17.5 Example for Configuring Remote Port Mirroring

Networking Requirements
As shown in
incoming traffic of Ethernet 0/0/2 on Switch A needs to be monitored on PC2. In this case, you
can configure remote port mirroring on Switch A.
Figure 8-8 Networking diagram of remote port mirroring
Eth 0/0/2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Issue 01 (2011-07-15)
Figure 8-8, Switch A is connected to PC1; Switch C is connected to PC2. Now,
SwitchA
Eth 0/0/1
Eth 0/0/2
PC1
Configure Ethernet 0/0/1 of Switch A as an observing port, and set the observing port as
an FR interface.
Configure Ethernet 0/0/2 of Switch A as a mirrored port.
Configure Ethernet 0/0/1 of Switch C as an observing port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB SwitchC
Eth 0/0/1
Eth 0/0/2
PC2
8 Mirroring
Eth 0/0/1
113