Configuring Dhcp Relay; Configuring The Ftp/Tftp Server; Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management

1.4.3 Configuring DHCP Relay

Context
The configuration procedure varies according to the device type of the DHCP relay. Therefore,
the configuration procedure is not described and only the configuration contents are provided.
Procedure
l
l
----End

1.4.4 Configuring the FTP/TFTP Server

Context
The configuration procedure varies according to the device type of the FTP/TFTP server.
Therefore, the configuration procedure is not described and only the configuration contents are
provided.
Procedure
l
l
l
----End

1.4.5 Checking the Configuration

Prerequisite
The configurations of the DHCP server, DHCP relay, and FTP/TFTP server are complete.
Issue 01 (2011-07-15)
Enable DHCP relay.
Configure the upstream and downstream interfaces.
You need to configure the IP address and mask for the upstream interface and configure
the IP address, mask, and DHCP relay address for the downstream interface.
NOTE
You can temporarily set the IP address of the downstream interface on the same network segment
with the IP addresses of unconfigured switches, and then add the downstream interface to the
management VLAN in access mode.
Set the IP address of the FTP/TFTP server.
For an FTP server, the IP address must be the same as the value of Option 143 configured
on the DHCP server; for a TFTP server, the IP address must be the same as the value of
Option 150 configured on the DHCP server.
Create and configure an intermediate file.
The intermediate file is configured according to the MAC addresses of unconfigured
switches and the names of configuration files. For the format of the intermediate file, see
1.1 Overview.
Save the intermediate file and configuration files to the working directory on the FTP/TFTP
server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Auto-Config
11