2. Check the controller Type field. If the Type field contains:
• W600E PowerLine Controller - Skip the rest of this section and proceed to
Section 4.1.2, Selecting an
• W600E Gradient Controller - Proceed to step 3.
3. Press the Setup function key to display the Gradient Controller Pump Setup screen
(Figure
It is not necessary to set any parameters on this screen right now. A description of
this screen and parameters appears in
4. Press the Pump Config screen key to display the Gradient Controller Pump
Configuration screen
50
Setting PowerLine Controller Operating Parameters
4-4).
Figure 4-4 Gradient Controller Pump Setup Screen
(Figure
Integrator.
Section 4.3, Setting Up the 600E
4-5).
Pump.