Setting Pump Parameters - Waters 600e User Manual

Accessing the Direct Control Screen
You set the run conditions from the Direct Control screen. To access the Direct Control
screen, press the Direct function key. The PowerLine Controller Direct Control screen
appears (Figure
Exiting the Direct Control Screen
To exit the Direct Control screen, press any function key to select another mode.

5.1.1 Setting Pump Parameters

Use the Direct Control screen
The pump parameters are:
• Flow
• %A, %B, %C, %D
• Sparge
• Temp
• Press
Attention: Be sure that the values for the maximum and minimum operating pressures
STOP
programmed on the Pump Setup screen are appropriate for your column. See
Section 4.3.2, Setting Pump Setup Parameters
Section 8.2.3, Exiting the Pump Setup Screen
the Column Care and Use Manual for guidelines.
88 Running PowerLine in Direct Control Mode
5-2).
Figure 5-2 PowerLine Controller Direct Control Screen
(Figure 5-2) to make manual changes to pump parameters.
(for PowerLine Controller operation), or
(for Gradient Controller operation). See