Starting A Run; Accessing The Operate Gradient Screen - Waters 600e User Manual

Canceling the Run
To cancel the run, press any function key, except the Operate Method key, to select another
mode.

11.3 Starting a Run

This section assumes that you have already set your initial operating parameters. If you
have not, review
Otherwise, proceed with the following topics:
•

Accessing the Operate Gradient screen

• Running a gradient
11.3.1 Accessing the Operate Gradient Screen
1. If the controller screen is not displaying the initial Operate Gradient screen (see
Figure
screen appears. Otherwise, go to step 2.
2. Move the cursor to the Table field on the initial Operate Gradient screen. Type a
table number (1 to 15) and press Enter.
3. Press the Operate Method function key. The second Operate Gradient screen
appears
194 Running Gradients
Section 11.2, Setting Initial Operating
11-3), press the Operate Method function key and the initial Operate Method
(Figure 11-4).
Figure 11-4 Second Operate Gradient Screen
Parameters, for requirements.