Waters 600e User Manual page 209

If the new line appears at the end of the table, the values from the previous line are
copied into the new line when you enter the time for that line. Edit the copied
conditions as necessary.
Saving Tables
Whenever you change a table, you must save the changes before powering down the
system.
The system does not retain parameters that you did not save. When you turn on the system
at a later time, the last table you saved is the default.
To save a table after you have entered all changes:
1. Press the Save screen key. The system displays:
Enter Table Number (1-15)
2. Type the number under which you want to save the table. Press Enter. The screen
displays:
Replace with New Table?
3. If you entered a table number under which no table is currently saved, type 1 and the
new table is saved under that table number.
4. If you entered the number of a table that has been previously saved, that preexisting
table appears on the screen.
• To overwrite the preexisting table, type 1. This erases the contents of the
preexisting table and replaces it with the new table.
• If you do not want to overwrite the preexisting table, type 0. The screen displays
the newly created table again.
5. To save the new table, repeat steps 1 through 3 and assign a different table number
to the table. Continue this process until you locate a table that can be replaced with
the new table.
Replacing Existing Tables
The controller can store a maximum of 15 tables (15 gradient and 15 event) in permanent
memory. Once you save 15 tables, you must replace one of these tables when you want to
save a new table.
To replace an existing table:
1. Move the cursor to the Table # field.
2. Type the number of the table you wish to replace. Press Enter.
1 = YES 0 = NO
Creating a Gradient Table 181