Propeller Shaft; Gearcase Lubricant - Evinrude E-TEC E115DPLSCR Service Manual

Propeller Shaft

Debris from the water can become lodged around
propeller shaft. Frequent inspection can minimize
potential gearcase damage.
WARNING
When servicing the propeller, always shift
the outboard to NEUTRAL, turn the key
switch OFF, and disconnect the battery
cables at the battery.
Remove propeller. Refer to Propeller Hardware
Installation on p. 67.
Inspect bushing and blade surfaces. Replace
damaged or worn propellers.
Clean propeller shaft. Inspect propeller shaft
seals. Replace damaged or worn seals.
Apply Triple-Guard grease to entire length of pro-
peller shaft prior to installing propeller.
Reinstall propeller hardware and propeller.

Gearcase Lubricant

Draining
WARNING
Gearcase lubricant may be under pressure
and/or hot. If plug is removed from a
recently operated outboard, take precau-
tions to avoid injury.
Always check the fill level of the
IMPORTANT:
gearcase lubricant at the upper plug before
removing the lower, drain/fill plug. A tie strap can
be used to check lubricant level.
1
1. Tie strap
Remove the lubricant level plug, then the lubricant
drain/fill plug, and drain the lube from the gear-
case into a container.
1. Lubricant level plug
2. Lubricant drain/fill plug
Inspection
Inspect the lube and the magnets on the plugs for
metal chips. The presence of metal fuzz can indi-
cate normal wear of the gears, bearings, or shafts
within the gearcase. Metal chips can indicate
extensive internal damage.
MAINTENANCE
LUBRICATION
3
000072
1
2
39514
79