Crankcase Disassembly; Cylinder Head Removal - Evinrude E-TEC E115DPLSCR Service Manual

Crankcase Disassembly

Use a 1/8 in. diameter pin punch to push crank-
case taper pin toward the front side of the engine.
Do not use a tapered punch or
IMPORTANT:
any other tool that could jam in or damage the
taper bore when removing the pin.
Remove crankcase flange screws.
1
1. Flange screws (12 on V4; 16 on V6)
Loosen in stages and remove the main bearing
screws.
1
1. Main bearing screws (6 on V4; 8 on V6)
Separate crankcase and cylinder block. It may be
necessary to tap on crankshaft with a rawhide or
rubber mallet to loosen.
Carefully remove the crankcase from the cylinder
block to avoid damaging the crankshaft seal rings.
005305

Cylinder Head Removal

Remove thermostat cover and thermostat assem-
bly. Refer to THERMOSTAT SERVICING on
p. 223.
Loosen in stages and remove cylinder head
retaining screws. Remove the cylinder head.
1
Discard thermostat seal and O-rings.
005306
1
1
1. Cylinder head screws (28 on V4; 40 on V6)
005313
POWERHEAD
POWERHEAD DISASSEMBLY
005304
1
11
005302
231