Powerhead Installation - Evinrude E-TEC E115DPLSCR Service Manual

Installation
Place mount assemblies in position, with flats fac-
ing away from each other.
Apply Moly Lube to all sides of retainer and install
between mounts.
Install the retainer screw and tighten to a torque of
15 to 20 ft. lbs. (20 to 27 N·m).
1. Mount retainer screw
POWERHEAD
INSTALLATION
Apply Permatex No. 2 to both sides of a new base
gasket around the exhaust port only. Install gasket
on adapter. To ensure proper sealing, mating sur-
faces must be clean and dry.
005310
1. Permatex No. 2
IMPORTANT:
NOT interchangeable. Be sure to use the correct
part.
Coat the driveshaft splines with Moly Lube. Do not
apply lubricant to end of driveshaft.
Use Lifting Tool, P/N 342672, and hoist to slowly
lower powerhead onto exhaust housing. If neces-
sary, rotate flywheel in a clockwise direction to
1
align crankshaft and driveshaft splines.
005309
POWERHEAD

POWERHEAD INSTALLATION

V4 and V6 base gaskets are
1
005258
11
005276
251