Shift Housing, Gear And Propeller Shaft Removal; Water Intake Screens - Evinrude E-TEC E115DPLSCR Service Manual

Install the upper driveshaft into the lower drive-
shaft, aligning the holes in the driveshaft retainer
and the lower driveshaft.
Install the roll pin to the specified dimension.
1
1. Roll pin
Shift Housing, Gear and
Propeller Shaft Removal
Push down on the shift rod. This will move the
detent lever downward to clear the inside of the
gearcase when the shaft assembly is pulled out.
Unscrew the shift rod from the detent lever.
Remove screws, cover, and shift rod from the
gearcase.
GEARCASE – STANDARD ROTATION
Discard the cover gasket. Remove and discard
the shift rod O-ring from inside of cover.
1
1. Cover gasket
29330
Remove propeller shaft assembly from gearcase.
0.125 in.
(3.2 mm)
DR4610

Water Intake Screens

Remove and clean water intake screens. Replace
if damaged.
1. Water intake screen
GEARCASE DISASSEMBLY
COA3141
006839
1
13
001991
315