Pinion Bearing Removal - Evinrude E-TEC E115DPLSCR Service Manual

Bearing and washer must be
IMPORTANT:
installed in the correct order.
2
1. Thrust bearing
2. Thrust washer
Align holes in the clutch dog with slot in the pro-
peller shaft. Install the clutch dog on the shaft with
"PROP END" facing rear of the shaft.
The clutch dog is not symmetri-
IMPORTANT:
cal. If installed backward, it will not fully engage
and will immediately damage itself and the gears.
1
1. "PROP END"
Slide the propeller shaft onto the shift shaft, align
the hole in the shaft with the hole in the clutch
dog, install the pin and then, a new clutch dog
retaining spring. Place three coils over each end
GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICE
of the pin, MAKING SURE NONE OF THE COILS
OVERLAP OR ARE LOOSE.
1
DSC02297
1. Retaining spring

Pinion Bearing Removal

Remove pinion bearing retaining screw.
1
1. Pinion bearing retaining screw
2. Water screen pocket
006840
3. Seal
Assemble Pinion Bearing Remover and Installer,
P/N 391257, in the gearcase as follows:
1
COB3101
2
3
DSC02370
DRC7416
DSC02313
13
319