Flywheel And Stator Servicing; Flywheel Removal - Evinrude E-TEC E115DPLSCR Service Manual

FLYWHEEL AND STATOR
SERVICING
Weak
IMPORTANT:
cause low alternator output and affect outboard
performance. Weak flywheel magnets can also
cause low readings on ignition test equipment,
such as a peak-reading voltmeter, which might
cause unnecessary parts replacement.
An accurate test of alternator output can help
determine the flywheel's condition. Refer to
CHARGING SYSTEM TESTS on p. 137.

Flywheel Removal

WARNING
To prevent accidental starting while ser-
vicing, disconnect battery cables at the
battery.
Remove the EMM. Refer to EMM SERVICING on
p. 110.
Disconnect the vapor separator vent hose, crank-
shaft position sensor, throttle position sensor, air
temperature sensor, and oil pump electrical con-
nectors.
Disconnect the stator connector, two port side trim
system connectors, port engine temperature sen-
sor, and the port ground terminal.
Remove the four screws holding the electrical har-
ness base.
1
1. Harness base screws
flywheel magnets can
1
005378
ELECTRICAL AND IGNITION

FLYWHEEL AND STATOR SERVICING

Lift the electrical harness base out of the way.
Use Flywheel Holder, P/N 771311, or equivalent,
and a socket to remove the five flywheel retaining
nuts and washers. Discard flywheel nuts.
1
1. Flywheel retaining nuts
CAUTION
To avoid damage to flywheel magnets, or
injury to fingers, Flywheel service kits,
P/N 434649 and P/N 5007181, must be
used to remove or install the flywheel.
Install bushing from Flywheel Puller Adaptor Kit,
P/N 5007181, on top of crankshaft. Place puller
from Flywheel Service Kit, P/N 434649, over
bushing.
005379
7
005380
151