Stator Service; Flywheel Installation - Evinrude E-TEC E115DPLSCR Service Manual

ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING
Use two 3/8-24x2 in. screws from the adaptor kit
to attach the tool to the flywheel. Two holes are
tapped in the flywheel for the tool.
1
2
1. Puller
2. Bushing
3. Screws - 3/8 - 24 x 2 in. (2)
Turn the center screw of the puller in to lift the fly-
wheel off of the crankshaft.
152

Stator Service

Remove six allen head screws to remove stator.
3
1
1. Stator screws
005369
To install stator, position stator on cylinder block.
Apply Nut Lock to screw threads. Install screws
and tighten in crossing pattern to a torque of 24 to
36 in. lbs. (3 to 4 N·m).

Flywheel Installation

If studs must be replaced in crankshaft, apply
Ultra Lock to threads and tighten by hand, no
more than 48 in. lbs. (5.5 N·m).
Remove any debris from the flywheel magnets
and the flywheel and crankshaft mating surfaces.
Apply Nut Lock to the raised mounting bosses on
the bottom of the flywheel.
005381
1
1. Flywheel mounting bosses
005382
005370