Pistons And Connecting Rods - Evinrude E-TEC E115DPLSCR Service Manual

POWERHEAD
POWERHEAD ASSEMBLY
lower housing with extended lip facing down.
Lubricate seal lip with Triple-Guard grease.
1. Extended lip
1. Seal lip
Install a new O-ring on the lower housing. Before
installing crankshaft into cylinder block, apply a
thin coat of Gasket Sealing Compound to outer
edge of O-ring.
Place lower seal housing on crankshaft.
1. O-ring
240
Thoroughly clean upper seal area of the crank-
shaft. Install new upper seal on crankshaft. Do not
apply sealer to outside diameter of the seal.
1
002036

Pistons and Connecting Rods

IMPORTANT:
1
tons in this engine are installed in the correct loca-
tion and direction.
New pistons are stamped "PORT" or "STBD," and
"EXH." These markings should be turned toward
the exhaust side (center) of the block. The splash
bowl on the dome of the piston will be located
toward the flywheel and opposite the exhaust port.
002037
1
1
1. Stamped markings
IMPORTANT:
connecting rods are installed with the alignment
005280
It is very important that the pis-
It is also very important that the
49068
1
005283