Intake Manifold Service - Evinrude E-TEC E115DPLSCR Service Manual

FUEL SYSTEM
FUEL COMPONENT SERVICING

Intake Manifold Service

Removal
Disconnect vapor separator vent hose, throttle
position sensor connector, and throttle link arm.
Remove crankshaft position sensor from reed
plate assembly.
Remove oil filter from retainer.
Remove oil pump bracket screws.
Remove throttle body screws and throttle body
assembly.
1
1. Throttle body screws (14 on V4, 18 on V6)
Remove gasket from throttle body.
Remove tie straps holding connectors to side of
reed plate assembly.
Remove two screws holding electrical harness
base to reed plate assembly.
1
1. Harness base screws
190
Remove oil distribution hoses from oil pump/mani-
fold and reed plate bracket. Refer to OIL COMPO-
NENT SERVICING on p. 211.
Remove oil recirculation hose from starboard side
of reed plate assembly.
Remove screws and reed plate assembly from the
crankcase.
1
1. Reed plate screws (3 on V4, 5 on V6)
Disassembly
All reed plate assembly and reed valve assem-
blies must be cleaned before reassembly. DO
NOT use strong carburetor cleaner or the hot
005368
soaking tank method for cleaning.
Remove the reed valve retainer screws and
remove the assembly.
1
005345
1
005367
005366