Shift Housing Assembly - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – COUNTER ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Wrap the housing with a shop cloth to catch ball
and spring. Pull the shifter detent straight out of
the housing.
1. Ball and spring
2. Shifter detent
Remove the detent ball and spring.
Remove needle bearings from bearing housing for
cleaning and inspection.

Shift Housing Assembly

Clean
IMPORTANT:
before beginning assembly procedures. Replace
any damaged parts.
Lightly coat the detent ball and spring with Needle
Bearing grease. Insert the spring in the housing,
then the ball.
Insert shifter detent into the housing as shown,
while depressing the ball and spring with a suit-
342
DSC02436
and inspect all parts
able tool. Once the detent is past the ball, remove
the tool and position detent to engage NEUTRAL.
2
1
1
1. Pin, shift lever (used as tool)
Thoroughly grease 25 needle bearings with Nee-
dle Bearing grease and place in the bearing case.
Rest the cradle and shift lever on the shift shaft
and insert through the front side of the shift hous-
ing.
4518
1. Cradle
2. Shift lever
DSC02442
4520
2
1
006860