Electrical Harness Connections - Evinrude E-TEC E115DPLSCR Service Manual

Electrical Harness Connections

Remove flywheel/harness connector cover.
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease
to the seal.
1. Seal
Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
1. Harness connections
INSTALLATION AND PREDELIVERY
Route oil tank sending unit harness around the
front to the port side. Secure all cables with tie
straps.
004954
1. Low oil sender connection
™
2. Tie straps
Install battery cables on starter solenoid and main
ground stud.
1
1
42079A
1. Positive (+) battery connection
2. Ground (–) connection
IMPORTANT:
wires are not pinched, cannot contact flywheel,
1
and do not interfere with moving throttle or shift
linkages.
Replace flywheel/harness connector cover.
004951
OUTBOARD RIGGING
BE SURE all harnesses and
2
1
2
004952
2
004953
55