Oil Component Servicing; Oil Distribution Hoses - Evinrude E-TEC E115DPLSCR Service Manual

OIL COMPONENT
SERVICING
WARNING
To prevent accidental starting while ser-
vicing, disconnect the battery cables at
the battery.

Oil Distribution Hoses

The oil distribution hoses from each manifold
MUST be the same length. DO NOT alter the
length of any hoses.
Oil Distribution Hose Length
Primary oil manifold to
cylinder block fitting
Rear oil manifold to
cylinder block fitting
Rear oil manifold to
primary oil manifold*
*Rear oil manifold to primary oil manifold hose
has a 0.160 in. I.D. and does NOT use a hose
support.
Removal
Release the hose by depressing the outer ring of
the hose retaining mechanism.
2
1
1. Retainer mechanism
2. Hose support
Once hose is removed from the manifold, make
sure hose support is in the end of the hose.
1
1. Hose support
Installation
Cut Replacement Oil Hose, P/N 778708, to the
12 in. (305 mm)
correct length. Insert hose support in manifold end
of hose. (Primary manifold to rear manifold hose
32 in. (812 mm)
does not use a hose support.)
32 in. (812 mm)
IMPORTANT:
into manifold without a hose support.
Be sure the hose is fully inserted into manifold.
Insertion depth is 5/8 in. (16 mm). Visually inspect
for hose supports.
005349
OILING SYSTEM

OIL COMPONENT SERVICING

DO NOT insert distribution hoses
DSC0290
9
211