Gearcase - Counter Rotation; Gearcase Disassembly; Pre-Disassembly Inspection; Propeller Shaft Bearing Housing Removal - "O" And "M" Type - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – COUNTER ROTATION

GEARCASE DISASSEMBLY

GEARCASE GEARCASE – COUNTER ROTATION
DISASSEMBLY
Counter rotation (CR) gearcases
IMPORTANT:
use unique components and require different ser-
vice procedures. Use care when working on
counter rotation gearcases. DO NOT interchange
parts between standard and counter rotation mod-
els. Identify gearcase type before disassembly.
Make sure the "CR" marking is on the end of the
propeller shaft.

Pre-Disassembly Inspection

Refer to Pre-Disassembly Inspection on p. 307.
Propeller Shaft Bearing Housing
Removal – "O" and "M" Type
Remove the two screws, washers, and retainers
holding the propeller shaft bearing housing.
1
1. "CR" marking
2. Retainer tab screws
Remove wedge, screw, and washer.
338
To remove the propeller shaft, bearing housing
and forward gear from gearcase, thread Propeller
Shaft Adapter, P/N 432398, onto Slide Hammer,
P/N 432128, until it seats. Thread adapter com-
pletely onto propeller shaft and pull propeller
shaft, bearing housing, and forward gear assem-
bly out of gearcase.
1
1. Adapter, P/N 432398
Propeller Shaft Bearing Housing
Removal – "M2" Type
IMPORTANT:
ing on "M2" type gearcases is PRESSED into
2
gearcase housing.
Remove the two retaining screws holding the pro-
peller shaft bearing housing.
1
001989
1. "CR" marking
2. Retainer screws
Remove the propeller shaft bearing housing from
the gearcase using:
Propeller Shaft Bearing Housing Puller Kit,
•
P/N 354060.
DSM02291
DSC02361
The propeller shaft bearing hous-
13501
2
006835