Water Pressure Gauge; Canbus Connections - Evinrude E-TEC E115DPLSCR Service Manual

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING

Water Pressure Gauge

If a mechanical water pressure gauge is used,
install the water pressure hose fitting in the cylin-
der block. Use Pipe Sealant with Teflon,
P/N 910048, on the threads of the hose fitting.
Refer to installation instructions supplied with
gauge.
Route the water pressure hose around the star-
board side of the powerhead along the same path
as the battery cables.
1. Water pressure hose fitting

CANbus Connections

If the outboard will be used with I-Command, or
other NMEA 2000 compliant CANbus instruments,
the following connections will supply information
to the network.
Connect the EMM CANbus connector to the CAN-
bus Network Harness.
1. EMM CANbus connector
56
Route the harness under the front of the EMM and
around the port side of the powerhead. Secure
with tie straps.
1
1
1. Harness routing
2. Tie straps
Use a CANbus Ignition Harness, in place of the
standard MWS harness, to connect the outboard
to the key switch and trim/tilt control. Seal unused
SystemCheck connector with 6-Pin Connector
Seal, P/N 586076.
004959
1
1. CANbus Ignition connector
2. Trim/Tilt connector
1
3. SystemCheck connector (with seal)
If installing a Deutsch-style I-Command network,
connect the purple wire from the CANbus Ignition
Harness to the CANbus network harness. This
connection supplies power to the network when
005267
1
2
005268
2
3
005266