Shift Linkage Installation; Throttle Linkage Installation - Evinrude E-TEC E115DPLSCR Service Manual

POWERHEAD
POWERHEAD ASSEMBLY

Shift Linkage Installation

Lubricate shift linkage bosses at the base of the
crankcase with Triple-Guard grease. Insert bush-
ings into bosses.
Apply Triple-Guard grease to the shaft of the shift
lever assembly. Guide shaft through bushings in
crankcase.
Install shift rod lever and tighten retaining screw
60 to 84 in. lbs. (7 to 9.5 N·m).
Apply Triple-Guard grease to shoulder of shift arm
screw and Nut Lock to threads. Install arm, screw,
and washer and tighten screw to a torque of 120
to 144 in. lbs. (13.5 to 16.5 N·m).
1
1. Shift arm screw
2. Shift lever screw
248

Throttle Linkage Installation

Apply Nut Lock to threads of throttle lever screw.
Insert spring into cavity of throttle lever.
Install lever, screw, and washer on crankcase and
hook spring on rib as shown. Tighten screw to a
torque of 120 to 144 in. lbs. (13.5 to 16.5 N·m).
1. Throttle lever spring
Apply Nut Lock to threads of throttle cam screw.
Install cam, screw, and washer on cylinder block
and tighten screw to a torque of 120 to 144 in. lbs.
2
(13.5 to 16 N·m).
005294
1
1. Throttle cam screw
IMPORTANT:
shoulder screws.
Do not lubricate throttle levers or
1
005259
005293