Propeller Shaft Bearing Housing Service - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICE
groove is an oil passage. Gearcase damage could
result.
1. O-ring (top groove)
2. Oil passage
Apply Gasket Sealing Compound to metal casings
of new seals before installing.
Use Seal Installation Tool, P/N 330268 to install
new seals back to back in bearing housing. Install
inner seal with lip facing toward bearing housing,
then the outer seal with lip facing away from bear-
ing housing. Apply Triple-Guard grease to seal
lips.
1. Inner seal
2. Outer seal
322
Propeller Shaft Bearing Housing
Service
Rear Seal Removal
1
Remove seals using Puller Bridge, P/N 432127,
and Small Puller Jaws, P/N 432131. Position the
plate on top of the housing to support the bridge,
and tighten jaws securely behind the inner seal.
2
14156
Bearing Removal
IMPORTANT:
bearing is removed for any reason, it must be dis-
carded.
Remove either bearing using Puller Bridge,
P/N 432127, and Large Puller Jaws, P/N 432129.
Rest the puller plate on top of the housing to sup-
1 port the bridge, and tighten the jaws securely
behind the bearing.
2
DR2061
DR2062
Inspect bearings in place. If a
13520
13522