Pinion Gear And Driveshaft Installation - "O", "L"' "L2", "M" And "M2" Type - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
Install new seals in driveshaft bearing housing.
Refer to Driveshaft Bearing Housing Service on
p. 321. Using Driveshaft
P/N 318674, slide the driveshaft bearing housing
onto the driveshaft.
1. Seal protector
Install washers on the driveshaft bearing housing
screws. Apply Gasket Sealing Compound to the
threads of the screws. Install screws and tighten
to a torque of 120 to 144 in. lbs. (13.5 to 16.5
N·m).
1
1. Driveshaft bearing housing screws
332
Pinion Gear and Driveshaft
Installation – "O", "L"' "L2", "M"
Seal Protector,
and "M2" Type
Refer to DRIVESHAFT SHIMMING on p. 325.
Install new seals in driveshaft bearing housing.
1
Refer to Driveshaft Bearing Housing Service on
p. 321.
Place the driveshaft thrust bearing, thrust washer,
and correct shim(s) on the driveshaft as shown.
COA3130
1. Thrust bearing
2. Thrust washer
3. Shim(s)
Using Driveshaft Seal Protector, P/N 318674,
slide the driveshaft bearing housing onto the
driveshaft and into position in the gearcase.
1
005425
1. Seal protector
Adjust shift rod to move clutch dog as far forward
as possible. Be sure excess grease is removed
from the pinion bearing.
3
2
1
COA3168
1
COA3130