Propeller Shaft Bearing Housing And Gear Installation - "M2" Type - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – COUNTER ROTATION
GEARCASE ASSEMBLY
Housing must be completely seated to install
retainer tabs.
Retainer Tab Notch
Install two retainers, washers and screws. Apply
Ultra Lock to threads and tighten screws to a
torque of 18 to 20 ft. lbs. (24 to 27 N·m).
1. Retainer tab screws
Loosen retainer screws 1/4 turn.
Install wedge, screw, and washer. Apply Ultra
Lock to threads and tighten screw to a torque of
15 to 20 in. lbs. (1.7 to 2.3 N·m).
354
Re-tighten two retainer screws to 18 to 20 ft. lbs.
(24 to 27 N·m).
Confirm that torque on the wedge screw is 15 to
20 in. lbs. (1.7 to 2.3 N·m).
Propeller Shaft Bearing
Housing and Gear Installation –
"M2" Type
IMPORTANT:
ing on "M2" type gearcases is PRESSED into the
gearcase housing.
50106a
Lightly apply Triple Guard Grease to new bearing
housing O-rings. Install O-rings in grooves in the
housing. Grease the machined side surfaces of
bearing housing.
Place bearing housing in gearcase.
1
001989
Align retaining holes in bearing housing with
screw holes in gearcase. Thread Alignment Pins,
P/N 354140, into gearcase.
DSM02291
DSC02361
The propeller shaft bearing hous-
006859
006847