Do you have a question about the 25 HP and is the answer not in the manual?
Questions and answers
Ken L. Angstead
April 28, 2025
I'm in need of new fuel line ends. The connector part for both ends. Are there different sizes of them and if so what size is required for this outboard motor and tank?
1 comments:
Mr. Anderson
May 15, 2025
The required fuel line connector end size for an Evinrude 25 HP outboard motor and tank is 5/16 inch. Internal (under the cover) fuel lines may be either 1/4 inch or 3/16 inch, and should be compared with new lines for proper sizing.
This answer is automatically generated
scott puckett
March 3, 2025
where is the tell tale discharge? should'nt i see a small stream of water coming out while the motor is running?
1 comments:
Mr. Anderson
March 3, 2025
The 1976 Evinrude 25 HP motor does not have a traditional tell tale (overboard indicator). Instead, water exits through the exhaust housing, which is normal for this model. If water is coming out of the exhaust port, the water pump is likely functioning correctly.
This answer is automatically generated
Mike Florek
June 28, 2025
how do I remove the hood on a 25 HP Evinrude E-tec outboard
Need help?
Do you have a question about the 25 HP and is the answer not in the manual?
Questions and answers
I'm in need of new fuel line ends. The connector part for both ends. Are there different sizes of them and if so what size is required for this outboard motor and tank?
The required fuel line connector end size for an Evinrude 25 HP outboard motor and tank is 5/16 inch. Internal (under the cover) fuel lines may be either 1/4 inch or 3/16 inch, and should be compared with new lines for proper sizing.
This answer is automatically generated
where is the tell tale discharge? should'nt i see a small stream of water coming out while the motor is running?
The 1976 Evinrude 25 HP motor does not have a traditional tell tale (overboard indicator). Instead, water exits through the exhaust housing, which is normal for this model. If water is coming out of the exhaust port, the water pump is likely functioning correctly.
This answer is automatically generated
how do I remove the hood on a 25 HP Evinrude E-tec outboard