Propeller Shaft Bearing Housing Removal - "S2", "O", "L" And "M" Type - Evinrude E-TEC E115DPLSCR Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE DISASSEMBLY
Propeller Shaft Bearing Housing
Removal – "S2", "O", "L" and "M"
Type
Identify gearcase type before dis-
IMPORTANT:
assembly. For counter rotation gearcases, refer to
GEARCASE DISASSEMBLY on p. 338.
Remove the two screws, washers, and retainers
holding the propeller shaft bearing housing.
1. Retainer tab screws
Remove wedge, screw, and washer.
308
Remove the propeller shaft bearing housing from
the gearcase using the following:
Puller body, screw, and handle from Universal
•
Puller Set, P/N 378103.
Two 5/16-18 x 11 in. (279 mm) threaded rods,
•
two large 5/16 in. I.D. flat washers, and two
5/16-18 nuts (obtain locally).
Assemble components and pull the bearing hous-
ing from the gearcase.
1
1. Bearing housing – slides in or out
001989
Remove the thrust washer, thrust bearing, and
reverse gear from gearcase.
DSM02291
DSC02361
1
22775