Pinion Gear And Driveshaft Installation - "S2" Type - Evinrude E-TEC E115DPLSCR Service Manual

Pinion Gear and Driveshaft
Installation – "S2" Type
Refer to DRIVESHAFT SHIMMING on p. 325.
Position the driveshaft thrust bearing, thrust
washer, and correct shim(s) on driveshaft as
shown.
3
2
1
1. Thrust bearing
2. Thrust washer
3. Shim(s)
Push down on shift rod to move the clutch dog to
reverse position. Pull propeller shaft aft to disen-
gage from forward gear and shift housing. Allow
shaft to drop against lower gearcase housing.
This will allow the installation of the pinion gear.
1. Propeller shaft
Forward gear and thrust bearing
IMPORTANT:
and washer can become misaligned. Make sure
forward thrust washer and thrust bearing and for-
ward gear are properly aligned with shift housing
before continuing gearcase assembly.
GEARCASE – STANDARD ROTATION
Install pinion gear in gearcase housing
Install driveshaft with thrust bearing, thrust
washer, and correct shim(s) in gearcase housing.
Position pinion on lower driveshaft.
005418
Position pinion screw in lower driveshaft and
1
thread into pinion.
005405
GEARCASE ASSEMBLY
005420
005410
005421
329
13