Service Specifications - Evinrude E-TEC E115DPLSCR Service Manual

INTRODUCTION

SERVICE SPECIFICATIONS

SERVICE SPECIFICATIONS
HP
Full Throttle
Operating Range
Power
Idle RPM in Gear
Test Propeller
Weight
(may vary depending
on model)
Lubrication
Engine Type
Displacement
Bore
Stroke
Standard Bore
Top Crankshaft Journal
Center Crankshaft Journals
Bottom Crankshaft Journal
Rod Crankpin
Piston Ring End Gap, Both
Fuel/Oil Ratio
Starting Enrichment
Preferred Fuel
Acceptable Fuel
Minimum (High) Fuel Pressure
@ IDLE RPM – 500 ± 50
Minimum Fuel Lift Pump Pressure
@ IDLE RPM – 500 ± 50
Maximum Fuel Inlet Vacuum
Minimum Octane
Additives
10
115
5500–6000 RPM
115 HP: (85.8 kw) @ 5750 RPM
550 ± 50
V4 20 in. (L) Models: P/N 386246 or P/N 433068
V4 25 in. (X) and V6 Standard Rotation Models: P/N 387388
V6 Counter Rotation Models: P/N 398673
20 in. (L) Models: 375 lbs. (170 kg)
25 in. (X) Models: 390 lbs. (177 kg)
Evinrude/Johnson XD100 Oil or Evinrude/Johnson XD50 Oil
Refer to Oil Requirements on p. 66
60° V 4-Cylinder Loop-Charged
105.4 cu. in. (1727 cm
3.6005 to 3.6015 in. (91.45 to 91.48 mm)
2.1870 to 2.1875 in. (55.55 to 55.56 mm)
2.1870 to 2.1875 in. (55.55 to 55.56 mm)
1.5747 to 1.5752 in. (40.0 to 40.01 mm)
1.3757 to 1.3762 in. (34.94 to 34.96 mm)
0.011 to 0.023 in. (0.28 to 0.58 mm)
See Fuel Requirements on p. 65 for additional information.
22 to 28 psi (152 to 193 kPa)
®
2+4 Fuel Conditioner, Fuel System Cleaner
Use of other additives may result in engine damage.
See Fuel Requirements on p. 65 for additional information.
150 HP: (111.9 kw) @ 5350 RPM
175 HP: (130.5 kw) @ 5350 RPM
200 HP: (149.1 kw) @ 5350 RPM
20 in. (L) Models: 418 lbs. (190 kg)
25 in. (X) Models: 433 lbs. (196 kg)
60° V 6-Cylinder Loop-Charged
3
) 158.2 cu. in. (2592 cm
3.601 in (91.47 mm)
2.588 in. (65.74 mm)
EMM Controlled
EMM Controlled
Regular unleaded gasoline
3 to 4 psi (21 to 28 kPa)
4 in. Hg. (13.5 kPa)
87 AKI (R+M)/2 or 90 RON
150, 175, 200
4850–5850 RPM
500 ± 50
3
)