Toshiba Tosvert VF-S15 Instruction Manual page 84

[How to read out parameters]
Use the EASY key to change between Easy setting mode and Standard setting mode, and then press the MODE
key to enter the setting monitor mode.
Turn the setting dial to read the parameter.
The relation between the parameter and the mode selected is shown below.
psel =0
* When the power is turned on, the inverter is in standard mode. Press the EASY key to switch to easy setting
mode.
psel =1
* When the power is turned on, the inverter is in easy setting mode. Press the EASY key to switch to standard
mode.
4

psel =2
* Always in easy setting mode.
However, it can be switched to standard setting mode by EASY key if it is set to psel=0, 1. When psel is
not displayed in Easy setting mode, undo is displayed and it can be temporarily switched to standard setting
mode by EASY key after center of the setting dial is pushed for five seconds or more.
D-16
E6581926