Toshiba Tosvert VF-S15 Instruction Manual page 161

 The jog run setting terminal (RES-CC) is enabled when the value of operation frequency is that of the jog
run frequency and below.
This connection does not function when operation frequency exceeds the jog run frequency.
 The motor can be operated in jog mode while the jog run setting terminals are connected (RES-CC).
 Jog run has priority to new operation command given during operation.
 Even for f261 = 0 or 1, an emergency DC braking (f603 = 2) is prior to the setting.
6
 No limits are imposed to the jog run frequency by the upper-limit frequency (parameter ul).
 Panel jog mode (if f262 is set to 1)
Here is the sequence in which modes change each time you press the
Note: When the inverter is in operation (RUN lamp is blinking) or when an operation command is issued
Set frequency
Forward
0
ST-CC
F-CC
R-CC
RES-
(=18)
Frequency command input
 The direction of rotation can change by using extension panel.
Using RKP007Z : Display switches to fjog and rjog by every pressing the FWD/REV key.
Using RKP002Z : Pressing the UP key changes display to fjog and pressing the DOWN key
changes display to rjog.
 When fjog is displayed, the inverter will be placed in forward jog run mode as long as the
key is pressed.
 When rjog is displayed, the inverter will be placed in reverse jog run mode as long as the
key is pressed.
 If you press and hold down the
be displayed.
M ODE
Status monitor
mode
MODE
(RUN lamp is lighting), the inverter cannot be switched to panel jog mode.
Forward
Forward
Reverse
key for 20 seconds or more, the key failure alarm "e-17" will
RUN
Standard monitor
mode
MODE
Setting monitor
mode
M ODE
Panel jog mode
F-50
E6581926
MODE
key.
RUN