(5)
(6)
Note5: Entry of setting is possible up to 3 times. Please note it is impossible to set, if you enter the
2) Resetting method of prohibition settings: f700 and f737
■ Resetting method
(1) Canceling the f700 prohibition setting
The setting of only parameter f700 can be changed at any time, even if it is set to 1 .
(2) Canceling he f737 prohibition setting
When this parameter is set to 1 (key operation prohibited), press and hold down the
seconds or more. The message und appears and this setting is canceled temporarily to enable key
operation. To cancel this setting permanently, change the setting of f737 directly
3) Setup method when parameter protection is necessary
6
■ Prohibit changing parameters settings and reading parameters from logic input
Set "Parameter editing prohibition" or "Parameter reading/editing prohibition" for an input terminal.
Activating the "Parameter editing prohibited" function prevents changes to parameters.
Activating the "Parameter reading/editing prohibition" function prevents reads and writes to parameters.
The following table shows an example of setting input terminal S1 and S2.
Title
f114
f115
Setting value 201, 203 are reverse signal.
When the password is removed, the setting for parameter f700 can be changed.
By setting parameter f700 = 0 , the all parameter settings can be changed.
wrong number for 3 times. Number of times is reset after power is off.
Function
Input terminal selection 4A
(S1)
Input terminal selection 5
(S2)
Adjustment range
200: PWP
0-203
(Parameter editing prohibition)
202: PRWP
0-203
(Parameter reading prohibition)
F-124
E6581926
ENT
key for 5
Setting