Troubleshooting Vrrp; An Error Prompt Is Displayed - HP 5900 Series Configuration Manual

Virtual IP
Member IP List : FE80::2 (Local, Master)
Forwarder Information: 2 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
The output shows that when Switch A fails, Switch B becomes the master because it has a higher
priority than Switch C, and the VF for virtual MAC address 000f-e2ff-4011 is removed.

Troubleshooting VRRP

An error prompt is displayed

Symptom
An error prompt "The virtual router detected a VRRP configuration error." is displayed during
configuration.
Analysis
This symptom is probably caused by the following reasons:
The VRRP advertisement interval in the packet is not the same as that for the current VRRP group (in
•
VRRPv2 only).
• The number of virtual IP addresses in the packet is not the same as that for the current VRRP group.
The virtual IP address list is not the same as that for the current VRRP group.
•
A device in the VRRP group receives illegitimate VRRP packets. For example, the IP address owner
•
receives a VRRP packet with the priority 255.
Solution
Modify the configuration on routers in VRRP groups to ensure consistent configuration.
•
• Take fault location and anti-attack measures to eliminate potential threats.
: FE80::10
1::10
FE80::3 (Backup)
: 255
: Active
: 000f-e2ff-4012 (Owner)
: 0000-5e01-1103
: 255
: local
: Listening
: 000f-e2ff-4013 (Learnt)
: 0000-5e01-1105
: 127
: FE80::3
: 1 State : Positive
117
Weight Reduced : 250