Icmp-Error Drop - HP MSR Series Command Reference Manual

Protocol: ICMP(1)
App: INVALID
Start time: 2011-07-29 19:12:33
Interface(in) : GigabitEthernet2/1/1
Interface(out): GigabitEthernet2/1/2
Initiator->Responder:
Responder->Initiator:
Total sessions found: 2
Table 56 Command output
Field
Initiator
Responder
Source IP/port
Dest IP/port
VPN-instance/VLAN ID/VLL ID
Protocol
App
State
Start time
TTL
Interface(in)
Interface(out)
Initiator->Responder
Responder->Initiator
Related commands
reset aspf session

icmp-error drop

Use icmp-error drop to enable ICMP error message check and drop faked messages.
State: ICMP_REQUEST
TTL: 55s
1 packets
0 packets
6048 bytes
0 bytes
Description
Session information from initiator to responder.
Session information from responder to initiator.
Source IP address and port number.
Destination IP address and port number.
•
VPN-instance—MPLS L3VPN where the session is initiated.
•
VLAN ID—ID of the Layer 2 VLAN in the packets of the
session.
•
VLL ID—Layer 2 INLINE to forward the session.
If no VPN, VLAN ID, or VLL ID is specified, this field displays a
hyphen (-).
Transport layer protocols, including DCCP, ICMP, ICMPv6,
Raw IP, SCTP, TCP, UDP, and UDP-Lite.
Number in parentheses represents the protocol number.
Application layer protocol.
INVALID specifies an unknown protocol, which uses an
unknown port.
Protocol status of the session.
Establishment time of the session.
Remaining lifetime of the session, in seconds.
Inbound interface of the session.
Outbound interface of the session.
Number of packets and bytes from initiator to responder.
Number of packets and bytes from responder to initiator.
440