Display Nat Outbound Port-Block-Group - HP MSR Series Command Reference Manual

The following items don't exist or aren't effective: global VPN, and ACL.
Global flow-table status: Active
Interface: GigabitEthernet1/2/0/1
DS-Lite B4 ACL: 2100
NO-PAT: N
Config status: Active
Table 37 Command output
Field
NAT outbound information
Interface
ACL
DS-Lite B4 ACL
Address group
Port-preserved
NO-PAT
Reversible
VPN instance
Config status
Reasons for inactive status
Global flow-table status
Reasons for flow-table inactive
status
Related commands
nat outbound

display nat outbound port-block-group

Use display nat outbound port-block-group to display information about port block group application
for NAT444.
Syntax
display nat outbound port-block-group
Address group: 0
Reversible: N
Description
Information about outbound dynamic NAT.
Interface where outbound dynamic NAT is configured.
IPv4 ACL number or name. If no IPv4 ACL is specified for outbound dynamic
NAT, this field displays hyphens (---).
Number or name of the IPv6 ACL used by DS-Lite NAT444.
Address group used by inbound dynamic NAT. If no address group is
specified for address translation, the field displays hyphens (---).
Whether to try to preserve the port numbers for PAT.
Whether NO-PAT is used:
•
Y—NO-PAT is used.
•
N—PAT is used.
Whether reverse address translation is allowed.
MPLS L3VPN instance to which the NAT address group belongs. If the
group does not belong to any VPN instance, the field is not displayed.
Status of the outbound dynamic NAT configuration: Active or Inactive.
Reasons why the outbound dynamic NAT configuration does not take
effect. This field is available when the Config status is Inactive.
Status of the flow entries deployed for the public IP addresses: Active or
Inactive.
Only distributed devices support this field.
Reasons why the flow entries do not take effect. This field is available when
the global flow table status is Inactive.
184
Port-preserved: N