Display Nat Static - HP MSR Series Command Reference Manual

Source security zone: DestZone
State: TCP_SYN_SENT
Application: SSH
Start time: 2011-07-29 19:12:36
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1
Table 43 Command output
Field
Initiator
Responder
DS-Lite tunnel peer
VPN instance/VLAN
ID/VLL ID
Protocol
Inbound interface
Source security zone
State
Application
Start time
TTL
Initiator->Responder
Responder->Initiator
Total sessions found
Related commands
reset nat session

display nat static

Use display nat static to display static NAT mappings.
Syntax
display nat static
Views
Any view
TTL: 28s
1 packets
0 packets
Description
Session information about an initiator.
Session information about a responder.
Destination address of the DS-Lite tunnel interface. If the session does not belong to
any DS-Lite tunnel, this field displays a hyphen (-).
MPLS L3VPN instance to which the session belongs.
VLAN ID to which the session belongs for Layer 2 forwarding.
INLINE to which the session belongs for Layer 2 forwarding.
If a setting is not specified, this field displays a hyphen (-).
Transport layer protocol type, DCCP, ICMP, Raw IP, SCTP, TCP, UDP, or UDP-Lite.
Input interface.
Source security zone to which the input interface belongs. If the input interface does
not belong to any security zone, this field displays a hyphen (-).
NAT session status.
Application layer protocol type, such as FTP and DNS.
This field displays OTHER for the protocol types identified by non-well-known ports.
Time when the session starts.
NAT session lifetime in seconds.
Number of packets and packet bytes from the initiator to the responder.
Number of packets and packet bytes from the responder to the initiator.
Total number of session tables.
197
48 bytes
0 bytes