Table 35 Command output
Field
NAT logging
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw
Alarm
Related commands
•
nat log enable
nat log flow-active
•
nat log flow-begin
•
display nat no-pat
Use display nat no-pat command to display information about NAT NO-PAT entries.
Syntax
Centralized devices in standalone mode:
display nat no-pat
Distributed devices in standalone mode/centralized devices in IRF mode:
display nat no-pat [ slot slot-number ]
Distributed devices in IRF mode:
display nat no-pat [ chassis chassis-number slot slot-number ]
Views
Any view
Default user roles
network-admin
network-operator
Description
NAT logging configuration.
Whether NAT logging is enabled.
If an ACL is specified for NAT logging, this field also displays the ACL
number.
Whether logging is enabled for NAT session establishment events.
Whether logging is enabled for NAT session removal events.
Whether logging is enabled for active NAT flows. If it is, this field also
displays the interval in minutes at which active flow logging is generated.
Whether logging is enabled for NAT444 port block assignment.
The device does not support this field in the current software version.
Whether logging is enabled for NAT444 port block withdrawal.
The device does not support this field in the current software version.
Whether logging is enabled for NAT444 alarms.
The device does not support this field in the current software version.
179