HP MSR Series Command Reference Manual page 176

Config status: Inactive
Reasons for inactive status:
The following items don't exist or aren't effective: interface IP address.
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT hairpinning:
Totally 2 interfaces enabled with NAT hairpinning.
Interface: GigabitEthernet2/0/1
Config status: Active
Interface: GigabitEthernet2/0/2
Config status: Active
NAT mapping behavior:
Mapping mode : Endpoint-Independent
ACL : 2050
Config status: Active
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled
PPTP : Enabled
RTSP : Enabled
RSH : Enabled
SCCP : Enabled
SIP : Enabled
SQLNET : Enabled
TFTP : Enabled
XDMCP : Disabled
NAT port block group information:
Totally 3 NAT port block groups.
Port block group 1:
Port range: 1-65535
Block size: 256
: Enabled(ACL 2000)
: Disabled
: Disabled
: Enabled(10 minutes)
: Disabled
: Disabled
162