Ipv6 Nd Ra Router-Lifetime; Ipv6 Nd Route-Direct Advertise - HP MSR Series Command Reference Manual

[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ipv6 nd ra prefix 2001:10::100 64 100 10

ipv6 nd ra router-lifetime

Use ipv6 nd ra router-lifetime to configure the router lifetime in RA messages.
Use undo ipv6 nd ra router-lifetime to restore the default.
Syntax
ipv6 nd ra router-lifetime value
undo ipv6 nd ra router-lifetime
Default
The router lifetime in RA messages is 1800 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Specifies the router lifetime in the range of 0 to 9000 seconds. If the value is set to 0, the router
does not act as the default router.
Usage guidelines
The router lifetime in RA messages specifies how long the router sending the RA messages acts as the
default router. Hosts receiving the RA messages check this value to determine whether to use the sending
router as the default router. If the router lifetime is 0, the router cannot be used as the default router.
The router lifetime in RA messages must be greater than or equal to the advertising interval.
Examples
# Set the router lifetime in RA messages on GigabitEthernet 2/0/1 to 1000 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ipv6 nd ra router-lifetime 1000
Related commands
ipv6 nd ra interval

ipv6 nd route-direct advertise

Use ipv6 nd route-direct advertise to enable ND direct route advertisement.
Use undo ipv6 nd route-direct advertise to disable ND direct route advertisement.
Syntax
ipv6 nd route-direct advertise
undo ipv6 nd route-direct advertise
358