Advpn Configuration Examples; Ipv4 Full-Mesh Advpn Configuration Example - HPE FlexNetwork HSR6800 Configuration Manual

ADVPN configuration examples

IPv4 full-mesh ADVPN configuration example

Network requirements
As shown in
information for all hubs and spokes. The AAA server performs authentication and accounting for
VAM clients. The two hubs back up each other, and perform data forwarding and route exchange.
•
Establish a permanent ADVPN tunnel between each spoke and each hub.
•
Establish a temporary ADVPN tunnel dynamically between the two spokes in the same ADVPN
domain.
Figure 139 Network diagram
Table 11 Interface and IP address assignment
Device
Hub 1
Hub 2
AAA server
Primary server
Secondary server
Configuring the primary VAM server
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure AAA:
# Configure RADIUS scheme abc.
Figure 139, the primary and secondary VAM servers manage and maintain VAM client
Interface IP address
GE2/1/1 1.0.0.1/24
Tunnel1 192.168.0.1/24
GE2/1/1 1.0.0.2/24
Tunnel1 192.168.0.2/24
1.0.0.10/24
GE2/1/1 1.0.0.11/24
GE2/1/1 1.0.0.12/24
Device
Spoke 1
Spoke 2
341
Interface IP address
GE2/1/1 1.0.0.3/24
GE2/1/2 192.168.1.1/24
Tunnel1 192.168.0.3/24
GE2/1/1 1.0.0.4/24
GE2/1/2 192.168.2.1/24
Tunnel1 192.168.0.4/24